Plastics Industry News
Neustadt-Fernthal, June 4, 2012
Even before the final of the European football championship in Poland the winner has been determined. During the PLASTPOL plastics fair in Kielce the BOY 35 E injection moulding machine showed its potential with an impressive performance.
In Hall F the four-tie bar BOY 35 E (clamping force 350 kN) that featured an energy-efficient servo drive, produced a PP membrane cage in a two-cavity mould. With a maximum injection volume of 76,5 cm³, the BOY 35 E meets all the requirements for the production of technically sophisticated precision parts.
With proven low machine hourly rates and a very favourable cost-performance ratio, the BOY 35 E has set new standards in its tonnage range. Since the introduction of the servo motor pump drive in 2008, more and more users have selected the energy efficient BOY E-Series. They benefit with each moulding cycle from the lower energy consumption. Through energy savings of up to 75 % the BOY E-Series machines can clearly reduce costs when compared to other drive technologies.
The highly precise, dynamic and extremely quiet BOY 35 E impressed the Plastpol attendees. They also liked the generous tie bar and platen dimensions as well as the compact footprint of only 1,9 m². “We are more than pleased with our performance”, stated Elisabeth Wlazlo of the Polish BOY distributor Wadim Plast Sp. j. “The extremely energy-efficient servo drive took centre stage. Nearly all discussions in the booth included the subject of energy saving”.
Dr. Boy GmbH & Co. KG is one of the leading worldwide manufacturers of injection moulding machines with clamping forces below 1,000 kN. Its precision, compact design, and attractive cost/performance ratio characterize the BOY product line. With innovative concepts and solutions, BOY sets new standards. Since the company was founded in 1968, 40,000 injection moulding machines have been delivered worldwide. The privately owned company continues to put special emphasis on engineering performance and high-class "made in Germany" workmanship.
Your contact person:
Head of Marketing
Dr. Boy GmbH & Co. KG
Neschener Straße 6
Tel : +27 11 823-5840 / 41 and 823-4952 / 54
Fax : +27 11 823-4969
Email : Send an Enquiry